For Smart 700cc petrol 450 or 452 (Roadster, Including BRABUS)
This Inlet Manifold is designed to be fitted on a new build engine using the GBC14-200 turbo but can be fitted as an after market upgrade.
Instructions to remove the old Manifold are at:
https://www.evilution.co.uk/mod/roadster-air-inlet-manifold-removal.htm?highlight=Inlet%20manifold
So I am not Going to go over them instructions again.
BEFORE ANY WORK IS DONE IN THIS AREA OF THE CAR IT IS IMPERATIVE A RISK ASSESSMENT IS DONE OF THE WORK AREA AND THE JOB TO BE TAKEN ON.
"IF YOU NOT CONFIDENT ABOUT DOING THIS JOB USE A PROFESSIONAL"
EXAMPLE:
YOU ARE DEALING WITH HIGH PRESSURE FUEL LINES AND IGNITION COILS. (NOT A GOOD COMBINATION). THERE IS A FIRE RISK. YOU NEED TO :
A) DISCONNECT THE BATTERY BEFORE YOU START WORK.
B) TURN THE HIGH PRESSURE FUEL PUMP ON BUT DO NOT START THE ENGINE AND INSPECT FOR FUEL LEAKS BEFORE INITIAL START UP.
C)
BE ABLE TO PUT THE FIRE OUT, IF THERE IS ONE.
D) MAKE SURE A FIRE CAN CAUSE MINIMAL DAMAGE, IF THERE IS ONE (YOU ARE NOT NEAR TREES OR OTHER FLAMMABLE OBJECTS.
A) Oil for lubricating parts on assembly.
B) ThreeBond 1184 gasket sealer.
C) 1/4" drive ratchet
D) 1/4" drive long extension
E) 1/4" drive long series 7mm socket
F) 1/4" drive long series E10 socket
G) 1/4" drive universal joint
H) 1/4" drive 5mm Hex Socket Bit
J) 1/4" drive 4mm Hex Socket Bit
K) 10mm combination spanner (wrench)
L) X-Acto knife with scraper blade
M) 4mm Hex Socket key
N) Magnet on a stick
P) Large Flat Screwdriver
Q) 1/4" drive spinner handle
R) Small Flat Screwdriver
S) Plug cap removal tool
T) Paper towels
Before you start the car turn on the ignition and go to the rear of the car and inspect for fuel leeks!
Here are 4 Finished installs
Contact
Company:
223D Developmental
41 St Georges Road
Torquay
Devon
TQ1 3QY
Email: mike@223.com
Phone: 44(0)7970108386